|
Randy Ayers Nascar Modeling Forums
|
View previous topic :: View next topic |
Author |
Message |
Tcart77
Joined: 28 May 2019 Posts: 25
|
Posted: Sun Nov 12, 2023 12:59 am Post subject: 98 taurus fit issues |
|
|
Having fit issues with revell monogram 1998 Taurus roll cage not letting body set down where it should. Usually build gm nascar, this is my first ford build. Looks like roll cage is hitting the roof up by the windshield.
Any ideas?
Thanks |
|
Back to top |
|
|
Vdc
Joined: 04 Sep 2022 Posts: 128
|
Posted: Sun Nov 12, 2023 11:39 am Post subject: |
|
|
A few places to adjust.
The roll cage, file down its front corners. Trim back the dash and maybe trim the engine bay bars.
Yeh, I like building kerbside!
Also, the wheel arches are not opposite each other. They're about 1mm off. I had to slot my wheel backs when fitting. |
|
Back to top |
|
|
john843
Joined: 28 Jan 2018 Posts: 607 Location: S.C. Lowcountry
|
Posted: Tue Nov 14, 2023 10:43 pm Post subject: |
|
|
I've only built one of those particular kits, a Jeff burton quite a while back and experienced the same issue. It was holding the body off a pretty good bit and the best I can remember, I ended up taking the cage out and taking about 1/16th or so from the bottom of the side bar assemblies and anywhere else that it glued to the pan. (Helped to use another unbuilt Taurus chassis to keep everything even). I also sanded material off the top of the hoop and sanded and tweaked the down bars at the A-pillar. I think I may have also relieved the forward outer corners of the dash some. All the while being careful not to let the dreaded space between the hoop and roof occur. On most of the Monograms I,'ve done, the cage will snug up to the roof without a lot of bother but I do remember this one needing therapy!
John |
|
Back to top |
|
|
Vdc
Joined: 04 Sep 2022 Posts: 128
|
Posted: Wed Nov 15, 2023 5:36 am Post subject: |
|
|
https://salhany.tripod.com/ModelFAQ.html
This link, great fitting info for these Taurus kits. Wheel track, cages and all sorts
Also, the roof flaps sit a little higher than the actual roof, so I sand them down level and their sharper edges do look better under the paint. |
|
Back to top |
|
|
TN Vols fan
Joined: 18 Jan 2022 Posts: 274 Location: Crossett, AR
|
Posted: Wed Nov 15, 2023 10:18 am Post subject: |
|
|
Vdc, Thank you for posting the FAQ. There's a lot of good information there. _________________ "Many men fish all their lives without knowing it is not the fish they are after." Henry David Thoreau
"I am, Sir, a brother of the angle" quote from The Compleat Angler, lzzak Walton 1654 |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|