|
Randy Ayers Nascar Modeling Forums
|
View previous topic :: View next topic |
Author |
Message |
hemiman_1999
Joined: 29 Jan 2018 Posts: 296
|
Posted: Wed May 23, 2018 11:17 am Post subject: Kit Info Needed |
|
|
I am working on an old MPC Richard Petty Roadrunner kit it a restoration project I am using a current Donnie Allison Merc for the chassis with some modifications I need to know which of the 3 holes was used to join the original 2 chassis plates together if any one could help I would appreciate it..Thanks.. |
|
Back to top |
|
|
Djaustinj53
Joined: 19 Mar 2018 Posts: 14
|
Posted: Wed May 23, 2018 12:23 pm Post subject: Kit info |
|
|
Place the body upside down. Put the front chassis section inside the body lining up the upper a-frames with the center of the front wheel openings. Now place the rear frame section inside the rear of the body and line up the wheel wells with the rear fender openings. This should give you the correct chassis length. Hope this helps. |
|
Back to top |
|
|
BVAUGHN
Joined: 29 Jan 2018 Posts: 505
|
Posted: Thu May 24, 2018 7:46 am Post subject: |
|
|
Looked at the original instructions. Goes in the middle hole .
Bill |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|