Randy Ayers Nascar Modeling Forums Forum Index Randy Ayers Nascar Modeling Forums

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Lionel 1/64 mustangs

 
Post new topic   Reply to topic    Randy Ayers Nascar Modeling Forums Forum Index -> The Diecast Den
View previous topic :: View next topic  
Author Message
ediskrad



Joined: 02 Mar 2018
Posts: 39

PostPosted: Tue Dec 03, 2019 12:27 am    Post subject: Lionel 1/64 mustangs Reply with quote

Received four 1/64 Action/Lionel NASCAR Mustangs today. On
each the grille is slightly off center and appears to have small bubbles as if a decal rather than Tampo. Has anyone seen this?
Back to top
View user's profile Send private message
Hitman51



Joined: 24 Dec 2018
Posts: 49

PostPosted: Mon Dec 09, 2019 12:53 pm    Post subject: Reply with quote

lionel has not tampo stamped a diecast in several years, probably 2010 or so. Never can quite figure out the method of graphics as they are VERY Thin and the inks are very bright. if you look hard enough you can see where the graphics edge starts and stops but they are in large sections and suck down nicely to the contours of the car.
Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    Randy Ayers Nascar Modeling Forums Forum Index -> The Diecast Den All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group