|
Randy Ayers Nascar Modeling Forums
|
View previous topic :: View next topic |
Author |
Message |
18degrees
Joined: 01 Feb 2018 Posts: 1021 Location: metro STL area, ILLINois
|
Posted: Sat Feb 03, 2018 12:21 am Post subject: What mods did you do to fix the stance of a new Fusion or SS |
|
|
I haven’t built a Fusion yet, but to fix the stance of a Chevy SS i did the following:
1. Removed the front brakes (result: pulled the wheels in)
2. Removed the air cleaner (result: lowered how the body sat on the chassis)
3. Removed the flat tabs to the front of the top of the dash (result: lowered how the body sat on the chassis)
I was ok with doing #1 but less than happy about #s 2 & 3, especially #2.
But it gives me perspective on when i build the next one... hopefully i can just mount the front wheels a little higher up on the suspension instead. _________________ ON DECK/IN THE WORKS: too many started to list...
|
|
Back to top |
|
|
martinfan
Joined: 29 Jan 2018 Posts: 270
|
|
Back to top |
|
|
18degrees
Joined: 01 Feb 2018 Posts: 1021 Location: metro STL area, ILLINois
|
Posted: Sat Feb 03, 2018 5:32 pm Post subject: |
|
|
I did watch that video a few days ago. I am considering shaving down where the front wheels attach and maybe seeing if i can use my pin vise to drill a hole a little bit higher up from the original and cutting the rear springs down like the video showed. Maybe then i won’t have to lower how the body sits via the tabs and air cleaner removal. _________________ ON DECK/IN THE WORKS: too many started to list...
|
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|