|
Randy Ayers Nascar Modeling Forums
|
View previous topic :: View next topic |
Author |
Message |
TiminToledo
Joined: 24 Jan 2022 Posts: 74
|
Posted: Fri Mar 29, 2024 7:54 pm Post subject: Salvinos Warped floors |
|
|
Any tips/tricks on how to get the floor pans in the Gen 7 cars flat?
I used warm/hot water and some weight to fix the first one I built (Bowman Camaro).
Second one I started, I had the water too hot, and it shrunk and is not repairable. Stole the pan out of another kit, but don't want to ruin it.
Thanks! |
|
Back to top |
|
|
jh63fan
Joined: 10 Sep 2021 Posts: 364 Location: Tarheel State
|
Posted: Sat Mar 30, 2024 6:46 am Post subject: |
|
|
I have had cold water running, heat it with a blow dryer for hair, over correct it and while still holding it in that position, put it under the stream of cold water. May have to do it a couple times.
You might check with Salvino JR, they might replace the bad part. |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|