|
Randy Ayers Nascar Modeling Forums
|
View previous topic :: View next topic |
Author |
Message |
Swede73
Joined: 21 Nov 2020 Posts: 3
|
Posted: Sun May 02, 2021 5:54 pm Post subject: Weaver dry sump parts, Gilmer (toothed) belt drives in scale |
|
|
Greetings,
Pretty much in the dark in relation to aftermarket suppliers as well as current kit content knowledge that might otherwise help me help myself, can anyone afford light guidance for someone looking for parts to work up a coherent Weaver dry sump set up for a system run in the early 1970's?
Specifically I'm after quality representations of toothed Gilmer belt drives or sprockets, the belt themselves, as well as stacked Weaver pressure or scavenge pumps - although the latter I could likely make. Tanks, fittings and a well as braided hose routing and such I can likely handle, although help to find the 'basic stuff' would help my cause immensely.
I'm plotting how to do a pair of '71/'72 AMC Javelin SCCA Trans-Am entries, and while my research materials are fortunately very good, my spares to support the builds and knowledge as to where to turn for materials is simply inadequate at this point. Kind thanks for your review of this post.
Mike K./Swede70 |
|
Back to top |
|
|
|
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
|